Add a new Carbon Copy which is billed to a specified Network/Mailbox.
String - GUID
This method adds a Carbon Copy configuration to the ECGrid Infrastructure. If an Interchange passes through ECGrid with a Sender & Receiver that matches the ECGridIDFrom and ECGridIDTo parameters, then a copy of that Interchange will be created using ECGridIDCCFrom and ECGridIDCCTo as the copy's Sender & Receiver.
TransactionSet is used to limit Carbon Copies to a specific Transaction Set and is standard dependant. Only the first transaction set in an interchange is compared. If a match, the entire interchange is forwarded. If left blank, will match all transaction sets. X12 matches ST01, EDIFACT matches UNH02, Tradacoms matches MHD02.
In order to make sure that data is not copied without proper authorization, either the ECGridIDFrom or ECGridIDTo must be on the Network/Mailbox making the request. Since it is possible that a legitimate requester may be the Carbon Copy Receiver, NetOps can override this limitation when authorization has been obtained from either the Original Sender or Original Receiver.
Carbon Copies are immediately active. Be sure to an Interconnect Request is in place for the ECGridIDCCFrom and ECGridIDCCTo before creating the Carbon Copy.
Please review Carbon Copies for limitations and special considerations depending on the Receiver's Network.
Any Carbon Copy created by this method will have any billable portions charged to the specified Network/Mailbox. A sufficient Authorization Level is required to make the assignment. To charge a Carbon Copy to the Session Network/Mailbox use CarbonCopyAdd().
|© 2008-2011, Loren Data Corp.
All rights reserved.
|ECGrid is a registered service
mark of Loren Data Corp.
ECGridOS is a service mark of Loren Data Corp.